With a power meter
If your trace carries watts (a meter paired with your watch or GPS bike computer), the Power section shows up. Konquo brings the readings to one value per second and skips gaps longer than 10 seconds, which are pauses.
- 1Avg power: the average of those per-second values. Coasting counts as 0 W.
- 2Max power: the highest reading in the trace.
- 3Normalized power: Konquo smooths your watts over 30 seconds, raises each value to the 4th power, averages them, then takes the fourth root. It gives surges more weight: on a stop-and-go ride, it ends up above the average.
- 4Estimated FTP: 95 % of your best 20-minute average, searched in this ride and your last 10 rides with power (90 days). Below 50 W, it is ignored.
Power zones
Your 7 zones (Konquo+) are bands of your FTP: Recovery below 55 %, Endurance from 55 to 75 %, Tempo from 75 to 90 %, Threshold from 90 to 105 %, VO2 max from 105 to 120 %, Anaerobic from 120 to 150 %, Sprint above that. Each measured second falls into one zone. Without a known FTP, they show up after a ride of more than 20 minutes with a meter. An FTP typed in your settings comes first.
Without a meter: estimated power
On a bike, the advanced analysis (Konquo+) estimates your power even without a meter. On each 20 m section, Konquo works out the effort against the slope, the tyres and the air at your speed, with your weight plus 9 kg of bike. You get the average, the 5-minute max, the power-to-weight ratio (W/kg) and the work in kJ. It needs altitude on at least half of the points. Since your weight is private, only you see this card.
Note: the Speed curve of the analysis shows your best pace held from 1 to 120 minutes, not your power.
Was this article helpful?
Log in to rate this article.
Log inStill got a question?
Our team replies on Discord or by email, in French and English.


