Elevation profile, elevation gain and climbs all start from the altitude recorded with each GPS point, smoothed before any calculation so that sensor noise does not add up.
Where the altitude comes from
With the app, it is the altitude given by your phone's GPS. For an imported activity, it is the one from your watch or GPS bike computer. Konquo does not correct it with a relief map.
Elevation gain and loss
Each altitude is replaced by the average of the 11 points around it (5 before, 5 after). Elevation gain is the sum of every rise between two smoothed points, elevation loss the sum of every drop. The elevation gain on your post, however, is the one recorded at the end of the activity, without this smoothing: it can differ a little from the detailed stats.
Terrain and grades (Konquo+)
The advanced analysis resamples the trace every 20 m, and smooths the altitude over about 100 m. Above a 2% grade it is uphill, below -2% downhill, in between flat. Max grade and max descent are measured over 100 m. The relief depends on the gain per km: flat below 10 m, rolling below 25 m, hilly below 50 m, mountain beyond.
Climbs and VAM (Konquo+)
A climb starts when the road goes up and ends as soon as you drop more than 10 m below its top. It is kept if it gains at least 20 m (30 m when cycling) with an average grade of at least 3%. Its category comes from its length in metres multiplied by its average grade in %:
| Length × grade, at least | Example | |
|---|---|---|
| Cat. 4 | 8,000 | 2 km at 4% |
| Cat. 3 | 16,000 | 2 km at 8% |
| Cat. 2 | 32,000 | 4 km at 8% |
| Cat. 1 | 64,000 | 8 km at 8% |
| HC | 80,000 | 10 km at 8% |
VAM is your climbing speed in metres per hour: the elevation gain of a climb divided by the time spent on it. Climbing VAM brings all your climbs together, and the 10 biggest are shown.
Was this article helpful?
Log in to rate this article.
Log inStill got a question?
Our team replies on Discord or by email, in French and English.


